- ページ 5

IP電話 Cisco 7931G - Unified IP Phone VoIPのPDF 管理マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 7931G - Unified IP Phone VoIP 12 ページ。 For cisco unified callmanager express 4.0
Cisco 7931G - Unified IP Phone VoIP にも: ユーザーマニュアル (20 ページ), 管理マニュアル (10 ページ), 管理マニュアル (17 ページ), 管理マニュアル (20 ページ), インストレーション・インストラクション (4 ページ), マニュアル (30 ページ), クイック・リファレンス (2 ページ), クイック・リファレンス・カード (2 ページ), ユーザーマニュアル (15 ページ)

Cisco 7931G - Unified IP Phone VoIP 管理マニュアル
Cisco Unified IP Phone Installation
Disable Headset
You can disable the headset by using Cisco Unified Communications Manager Administration.
To disable the headset, perform the following steps:
Procedure
Step 1
Choose Device > Phone and locate the phone you want to modify.
Step 2
In the Phone Configuration window, check the Disable Speakerphone and Headset check box.
Step 3
Click Apply.
External Device Use
Cisco recommends the use of good quality external devices, such as speakers, microphones, and headsets that
are shielded (screened) against unwanted radio frequency (RF) and audio frequency (AF) signals.
Depending on the quality of these devices and their proximity to other devices, such as mobile phones or
two-way radios, some audio noise may still occur. In these cases, Cisco recommends that you take one or
more of the following actions:
• Move the external device away from the source of the RF or AF signals.
• Route the external device cables away from the source of the RF or AF signals.
• Use shielded cables for the external device, or use cables with a better shield and connector.
• Shorten the length of the external device cable.
• Apply ferrites or other such devices on the cables for the external device.
Cisco cannot guarantee the performance of the system because Cisco has no control over the quality of external
devices, cables, and connectors. The system performs adequately when suitable devices are attached with
good quality cables and connectors.
In European Union countries, use only external headsets that are fully compliant with the EMC Directive
Caution
[89/336/EC].

Install Cisco Unified IP Phone

You must connect the Cisco Unified IP Phone to the network and to a power source before using it. For a
graphical representation of the connections, see
Perform the following steps to install a Cisco Unified IP Phone.
Cisco Unified IP Phone 7931G Administration Guide for Cisco Unified Communications Manager 9.0 (SCCP and SIP)
Cisco Unified IP Phone 7931G Connections, on page
Install Cisco Unified IP Phone
6.
5