- ページ 19

スイッチ Siemens SITRANS LVL200EのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SITRANS LVL200E 40 ページ。 Vibrating switches
Siemens SITRANS LVL200E にも：取扱説明書 (40 ページ), 取扱説明書 (44 ページ), 取扱説明書 (16 ページ)

ページを印刷する

Electronics and terminal

compartment

Wiring plan

*7ML19985KY01*

4. Insert the cable into the sensor through the cable entry

5. Open the terminals with a screwdriver

6. Insert the wire ends into the open terminals according to the wir-

ing plan

7. Tighten the terminals with a screwdriver

8. Check the hold of the wires in the terminals by lightly pulling on

them

9. Tighten the compression nut of the cable entry gland. The seal

ring must completely encircle the cable

10. Screw the housing lid back on

The electrical connection is finished.

5.3

Wiring plan, single chamber housing

The following illustrations apply to the non-Ex as well as to the Ex-d

version.

Fig. 10: Electronics and terminal compartment, single chamber housing

Control lamp

DIL switch for characteristics reversal

DIL switch for sensitivity adjustment

Ground terminal

5 EMC filter element

Simulation key

Connection terminals

For connection of the amplifier according to NAMUR (IEC 60947-5-6,

EN 50227). You can find further information in the "Technical data".

SITRANS LVL200E - Operating Instructions

SW E60N Ex

N A M U R

( I E C 6 0 9 4 7 - 5 - 6 )

+ -

0,5 g / cm 3

M a x .

S i m u l .

0,7 g / cm 3

M i n .