- ページ 30

食器洗い機 Siemens dishwasherのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens dishwasher 34 ページ。 Dishwasher
Siemens dishwasher にも： 取扱説明書 (29 ページ), 取扱説明書 (30 ページ), 取扱説明書 (30 ページ), 取扱説明書 (30 ページ), 取扱説明書 (28 ページ), 取扱説明書 (26 ページ), 取扱説明書 (28 ページ), 取扱説明書 (26 ページ), 取扱説明書 (28 ページ), 取扱説明書 (32 ページ), 取扱説明書 (28 ページ), 取扱説明書 (34 ページ), 取扱説明書 (28 ページ), 取扱説明書 (34 ページ), 取扱説明書 (26 ページ), 取扱説明書 (40 ページ), 取扱説明書 (31 ページ), 取扱説明書 (40 ページ), 取扱説明書 (24 ページ), 取扱説明書 (28 ページ), 取扱説明書 (28 ページ)

ページを印刷する
Siemens dishwasher 取扱説明書
en
Fresh-water connection
Connect the inlet hose to a water tap using
the enclosed parts and in accordance with
the installation instructions.
Water pressure:
Minimum 0,5 bar – maximum 10 bar.
If the water pressure is higher, install a
pressure reducing valve.
Flow rate:
Minimum of 10 litres per minute.
Water temperature:
We recommend that you use cold water.
If you do use hot water, the temperature
should not exceed 60 °C.

Electrical connection

This appliance should only be connected
to a 230/240 V AC source via a properly
installed earthed socket. See nameplate
for size of required fuse.
32
The socket must be installed close to the
dishwasher.
If you need to extend the mains
connecting lead, do not cut off the plug.
Replace the whole cable, which can be
disconnected at the junction box on the
rear of the appliance.
If the domestic wiring includes a residual-
current-operated (FI) circuit-breaker, make
sure that it bears the
this type conforms to the latest regulations

Disconnecting the dishwasher

Here too, it is important that tasks are
carried out in the correct sequence:
always unplug the appliance from the
mains electricity first of all.
Pull plug out of wall socket.
Turn off water supply.
Disconnect drain and water input hoses.
Remove screws in underside of work
surface. Detach base board, if fitted.
Pull out appliance and carefully withdraw
hoses at same time.
30
mark, as only
Transportation
Empty the dishwasher according to
the following steps:
Turn on the tap.
Switch on the appliance.
Start any automatic programme
and close the appliance door.
Wait until approx. 4 minutes have
elapsed.
Then open the door, terminate
the programme and close the door
to drain the appliance.
Wait until the buzzer is emitted 5 times,
i.e. all the water has been drained.
Switch off the appliance.
Turn off the tap.
Secure loose parts prior to transportation.
Transport the appliance upright only.
Otherwise, residual water may penetrate
the control and damage the appliance.
Protection from freezing
temperatures
If the appliance is installed in a location
where there is a risk of freezing
temperatures (e.g. in a holiday home), all
water must be completely drained out of
the interior (see "Transporting the
dishwasher").
Turn OFF the tap, disconnect the supply
hose and allow to drain.