- ページ 18
食器洗い機 Siemens DishwashersのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens Dishwashers 30 ページ。 Dishwasher
Siemens Dishwashers にも： 取扱説明書 (30 ページ), 取扱説明書 (28 ページ)
ページを印刷する
en
Switching off automatically after
the end of the programme
To save energy, the dishwasher is
switched off 1 minute after the programme
ends (factory setting).
Automatic disconnection can be adjusted
from :
to :
:
Appliance does not switch off
automatically
:
Off after 1 min
:
Off after 120 min
– Open the door.
– Switch on ON/OFF switch (.
– Hold down programme button # and
press START button )" until : ... is
indicated on the digital display.
– Release both buttons.
The LED for button # flashes and the
digital display 8 displays the factory
setting :
.
– Press programme button # until the
factory set value :
the digital display 8.
To change the setting:
– Press programme button 3.
Each time the button is pressed, the
set value increases by one level; when
the value of :
the display jumps back to :
– Press START button )".
The set value is saved.
– Close the door.
Switching off the appliance
Short time after the end of the programme:
– Open the door.
– Switch off ON/OFF switch (.
– Turn off the tap (not applicable if Aqua-
Stop fitted).
– Remove the utensils when they have
cooled down.
18
.
is indicated on
has been reached,
(off).
ã=
Warning
At the end of the programme please open
the door fully and not partially when
emptying the dishwasher. Any escaping
water vapour could damage sensitive
worktops.
Interrupting the programme
– Open the door.
– Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave the
door ajar for several minutes and then
close. Otherwise, expansion (pressure)
may cause the appliance door to
spring open or water to run out of the
appliance.
– To continue the programme, switch on
the ON/OFF switch ( again.
– Close the door.
Terminating the programme
(Reset)
– Open the door.
– Press START button )" for
approx. 3 sec.
The numerical display 8 indicates
:
.
– Close the door.
The programme sequence lasts
approx. 1 min. On the digital display
8 is indicated :
– Open the door.
– Switch off ON/OFF switch (.
– Close the door.
.