- ページ 22

食器洗い機 Siemens SN SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SN Series 42 ページ。 Dishwasher
Siemens SN Series にも: 操作上の注意 (38 ページ), 取扱説明書 (38 ページ), 取扱説明書 (42 ページ), 取扱説明書 (44 ページ), 取扱説明書 (46 ページ), 取扱説明書 (44 ページ), 取扱説明書 (42 ページ), 取扱説明書 (48 ページ), 取扱説明書 (40 ページ), 取扱説明書 (42 ページ), 取扱説明書 (44 ページ), 取扱説明書 (40 ページ)

Siemens SN Series 取扱説明書
en
Operating the appliance
Note
- for environmentally friendly operation
of the dishwasher:
For ecological reasons the Eco 50°
programme is preset whenever the
appliance starts. This conserves
environmental resources and not least
saves you money.
The Eco 50° programme is a
particularly environmentally friendly
programme. According to EU
regulation 1016/2010 it is the
"Standard programme" which is the
most efficient standard cleaning cycle
for cleaning normally soiled utensils in
terms of the combined energy and
water consumption for cleaning these
types of utensils.
P rogramme sequence
Pr o g r a m m e s e q u e n c e in d i c a t o r
indicator )"
-/,
Your dishes are being
cleaned.
5/%
Your dishes are being rinsed.
Your dishes are being rinsed.
Your dishes are being rinsed.
=/<
Your dishes are being dried.
Your dishes are being dried.
Your dishes are being dried.
Remaining running time
Remaining running time
Remaining running time
display
When the programme is selected, the
When the programme is selected, the
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )*.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
22

Timer programming *

Ti m e r pr o g r a m mi n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button X + until the digital
display )* jumps to
4. Press X + or – button until the
displayed time corresponds with your
requirements.
5. Press START button h, timer
Press START button
Press START button
programming is activated.
programming is activated.
programming is activated.
6. To delete timer programming, press
To delete timer programming, press
To delete timer programming, press
the X + or – button until )* :
X
X
+ or – button until
+ or – button until
is indicated on the digital display.
is indicated on the digital display.
is indicated on the digital display.
You can change your programme
You can change your programme
You can change your programme
selection at any time until the
selection at any time until the
selection at any time until the
programme starts.
programme starts.
programme starts.

End of programme

End of programme
End of programme
The programme has ended when the
value :
is indicated on the numerical
display )*.
:
.