- ページ 23

食器洗い機 Siemens SN SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SN Series 42 ページ。 Dishwasher
Siemens SN Series にも: 操作上の注意 (38 ページ), 取扱説明書 (38 ページ), 取扱説明書 (42 ページ), 取扱説明書 (42 ページ), 取扱説明書 (44 ページ), 取扱説明書 (46 ページ), 取扱説明書 (44 ページ), 取扱説明書 (42 ページ), 取扱説明書 (48 ページ), 取扱説明書 (40 ページ), 取扱説明書 (44 ページ), 取扱説明書 (40 ページ)

Siemens SN Series 取扱説明書
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display )".
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Close the door.
2. Switch on ON/OFF switch (.
3. Press button @ + until the digital
display )" jumps to :
4. Press @ + or – button until the
displayed time corresponds with your
requirements.
5. Press START button P, timer
programming is activated.
6. To delete timer programming, press
the @ + or – button until )" :
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.

End of programme

The programme has ended when the
value :
is indicated on the numerical
display )".
Switching off automatically
after the end of
the programme *
* depending on model
To save energy, the dishwasher is
switched off 1 minute after the
programme ends (factory setting).
Automatic disconnection
can be adjusted from :
:
:
:
1. Close the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
4. Release both buttons.
.
5. Press programme button # until
To change the setting:
1. Press programme button 3.
2. Press START button P.
Operating the appliance
Appliance does not switch off
automatically
Off after 1 min
Off after 120 min
and press START button P
until : ... is indicated on the digital
display.
The LED for button # flashes and
the digital display )" displays the
factory setting :
the factory set value :
is indicated on the digital
display )".
Each time the button is pressed, the
set value increases by one level;
when the value of :
reached, the display jumps back
to :
(off).
The set value is saved.
en
S w i t c h i n g o f f a u t o m a t i c a l l y a f t e r t h e e n d o f t h e p r o g r a m m e
to :
.
.
has been
23