- ページ 23
食器洗い機 Siemens SN23E831TIのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SN23E831TI 40 ページ。
ページを印刷する
End of programme
The programme has ended when
neither of the two displays )" or )* is
lit.
Note
To save energy, the dishwasher
automatically switches off after the end
of the programme.
Interrupting the programme
1. Switch off ON/OFF switch (.
The LEDs go out. The programme is
saved.
If the door was opened on an
appliance which has a warm water
connection or is heated, first leave
the door ajar for several minutes and
then close. Otherwise, expansion
(pressure) may cause the appliance
door to spring open or water to run
out of the appliance.
2. To continue the programme, switch
on the ON/OFF switch ( again.
T erminating the programme
T e r m i n a t i n g t h e p r o g r a m m e
(Reset)
1. Press START button @ for
approx. 3 sec. until all displays go
out.
2. The remaining programme sequence
for draining the residual water takes
approx. 1 minute.
Operating the appliance
Changing the programme
When the START button @ has been
pressed, the programme cannot be
changed.
The only way a programme can be
changed is by Cancel programme
(Reset).
Intensive drying
The final rinse uses a higher
temperature which improves the drying
result. The running time may increase
slightly. (Caution if utensils are delicate!)
1. Close the door.
2. Switch on ON/OFF switch (.
The Cleaning display )* flashes.
3. Press and hold down the START
button @.
4. Rotate programme selector 8 until
the "Check water supply" display
h flashes.
5. Release button.
To change the setting:
1. By rotating the programme selector
8, you can switch on intensive
drying (Dry display )"
is lit) or switch off intensive drying
(Dry display )" is not lit).
2. Press START button @.
The setting is saved.
en
23