- ページ 32

食器洗い機 Siemens SX SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SX Series 44 ページ。 Dishwasher
Siemens SX Series にも： 操作上の注意 (38 ページ), 取扱説明書 (38 ページ), 取扱説明書 (42 ページ), 取扱説明書 (42 ページ), 取扱説明書 (44 ページ), 取扱説明書 (46 ページ), 取扱説明書 (42 ページ), 取扱説明書 (48 ページ), 取扱説明書 (40 ページ), 取扱説明書 (42 ページ), 取扱説明書 (44 ページ), 取扱説明書 (40 ページ)

ページを印刷する
Siemens SX Series 取扱説明書
en
Fault, what to do?
Fault
Error code ":Ġ is lit.
Error code ":ƒˆ is lit.
A different error code is
indicated on the digital
display.
(":‹‚ to ":„‹)
Display flashes.
Refill indicator for salt @
and/or rinse-aid H is lit.
Refill indicator for salt @
and/or rinse-aid H is not
lit.
Water is left in the
appliance at the end of the
programme.
32
Cause
Waste water pump blocked or
cover on the waste water pump is
not locked in position.
Mains voltage too low.
A technical fault has probably
occurred.
Door not closed properly.
No rinse aid.
No salt.
Sensor does not detect salt
tablets.
Refill indicator switched off.
There is still enough special salt/
rinse aid available.
Filter system or area under the
filters 1Z is blocked.
Program has not ended yet.
Remedial action
Clean pump and lock cover correctly. (See
"Waste water pump")
Not an appliance fault, have the mains
voltage and electrical installation checked.
Switch off appliances with the ON/OFF
switch (. After a short time restart the
appliance.
If the problem recurs, turn off the tap and
pull out the mains plug.
Call customer service and mention the error
code.
Close the door. Ensure that no objects
(utensil, fragrance dispenser) are protruding
over the basket and preventing the door
from closing.
Refill rinse aid.
Refill with special salt.
Use different special salt.
Activation/deactivation (see chapter Water
softening system/Special salt or Rinse aid).
Check refill indicator, levels.
Clean filters and area underneath (see
"Waste water pump").
Wait until programme ends or reset (see
"Terminating the programme").