- ページ 24

食器洗い機 Siemens SX SeriesのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens SX Series 44 ページ。 Dishwasher
Siemens SX Series にも： 操作上の注意 (38 ページ), 取扱説明書 (38 ページ), 取扱説明書 (42 ページ), 取扱説明書 (42 ページ), 取扱説明書 (44 ページ), 取扱説明書 (46 ページ), 取扱説明書 (44 ページ), 取扱説明書 (42 ページ), 取扱説明書 (48 ページ), 取扱説明書 (40 ページ), 取扱説明書 (42 ページ), 取扱説明書 (40 ページ)

ページを印刷する
Siemens SX Series 取扱説明書
en
Operating the appliance
Remaining running time
display
When the programme is selected, the
remaining running time of the
programme is indicated on the digital
display h.
The running time is determined during
the programme by the water
temperature, the number of utensils as
well as the degree of soiling and may
vary (depending on the selected
programme).
T imer programming *
T i m e r p r o g r a m m i n g
* depending on model
You can delay the start of the
programme in 1-hour steps up to
24 hours.
1. Open the door.
2. Switch on ON/OFF switch (.
3. Press button P + until the digital
display h jumps to :
4. Press P + or – button until the
displayed time corresponds with your
requirements.
5. Press START button `, timer
programming is activated.
6. To delete timer programming, press
the P + or – button until h :
is indicated on the digital display.
You can change your programme
selection at any time until the
programme starts.
7. Close the door.
24

End of programme

The programme has ended when the
value :
display h.
The end of the programme is also
indicated by an acoustic signal. This
function can be changed as follows:
1. Open the door.
2. Switch on ON/OFF switch (.
3. Hold down programme button #
4. Release both buttons.
5. Press programme button # until
To change the setting,
1. Press programme button 3. Each
.
2. Press START button `, the set
3. Close the door.
is indicated on the numerical
and press START button ` until
: .... is indicated on the digital
display.
The LED for button # flashes and
the digital display h displays the
factory setting :
the factory set value :
indicated on the digital display h.
time the button is pressed, the set
value increases by one level; when
the value of :
the display jumps back to :
value is saved.
.
is
has been reached,
(off).