- ページ 11

ホブ Siemens EC6A5IB90AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Siemens EC6A5IB90A 20 ページ。

ページを印刷する

--------

Code

HZ233540 Additional wok grid: Cast iron (4-5 kW)

HZ233440 Additional wok grid: Cast iron (mini wok

burner)

HZ241110 Additional espresso maker grid

HZ298105 Simmer Plate

HZ211310 Simmer cap

The manufacturer accepts no liability if these

accessories are not used or are used incorrectly.

ÄGas burners

S witching on manually

G a s b u r n e r s

Press the control knob for the selected burner and

turn it anticlockwise to the highest power setting.

Hold an igniter or a naked flame (such as a lighter or

a match) against the burner.

Automatic ignition

If the hob has automatic ignition (ignition plugs):

Press the control knob for the selected burner and

turn it anticlockwise to the highest power level.

While the control knob is held down, all the burners

will generate sparks. The flame ignites. Wait a few

seconds.

Release the control knob.

Turn the control knob to the required position.

If the burner does not ignite, switch it off and repeat the

steps described above. This time, hold the control knob

down for longer (up to 10 seconds).

Simmer plate

This accessory part is only suita-

ble for simmering. It can be

used with the economy burner

or the standard-output burner. If

your hob has several standard-

output burners, we recommend

placing the simmer plate on the

rear or front-right standard-out-

put burner.

Place the accessory component

with the projections facing

upwards on the holder; never

place it directly on the burner.

Simmer cap

Only use the cap for cooking

with minimal power. Place the

simmer cap on the cover of the

economy burner. Always place

cookware on the pan support,

never directly on the simmer

cap.

Warning – Risk of deflagration!

If the flame does not ignite after 15 seconds, switch off

the burner and open a window or the door to the room.

Wait at least one minute before switching the burner on

again.

It is important to keep the appliance clean. If the

Note:

ignition plugs are dirty, this may cause ignition

problems. Clean the ignition plugs regularly with a

small, non-metallic brush. Take care to prevent the

ignition plugs from suffering any heavy knocks.

Safety system

Your hob is equipped with a safety system

(thermocouple) that cuts off the gas when the burners

are accidentally switched off.

To ensure that this device is active:

Switch on the burner as usual.

Without releasing the control knob, press and hold it

down firmly for 4 seconds after lighting the flame.

Switching off a burner

Turn the corresponding control knob clockwise to the 0

setting.

A few seconds after the burner is switched off, a sound

(thud) will be produced. This is not a fault - this means

that the safety device is no longer operating.

Warnings

It is normal to hear a soft whistling noise while the

burner is operating.

When first used, it is normal for the burner to give off

odours. This does not pose any risk and does not

indicate a malfunction. They will disappear in time.

An orange-coloured flame is normal. This is caused by

the presence of dust in the atmosphere, spilt liquids,

etc.

In the event of the burner flames being accidentally

extinguished, turn off the burner control and do not

attempt to re-ignite the burner for at least one minute.