- ページ 15

ホブ Siemens EC745RT90AのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Siemens EC745RT90A 25 ページ。

ページを印刷する

Switching on

automatically

Safety system

Fig. 15

Ignition

Thermocouple

sparker

Switching off a burner

Power levels

If your cooktop can be switched on automatically (ignition

sparkers):

1. Press the chosen burner control knob and turn it

anticlockwise to the maximum power setting.

While the control knob is still pressed down, sparks are

produced on all burners. The flame ignites (it is no longer

necessary to press down the control knob).

2. Turn the control knob to the required setting.

If it does not come on, turn the control knob to the off

setting and repeat the steps above. This time, press and

hold the control knob for longer (up to 10 seconds).

Warning! If after 15 seconds the flame does not ignite,

switch off the burner and open a nearby window or door.

Wait at least one minute before trying to switch the burner

on.

Depending on the model, your cooktop may have a

safety system (thermocouple) that prevents the flow of

gas if the burners accidentally switch off. To ensure that

this device is active, switch on the burner as usual and,

without releasing the control knob, press and hold it

down firmly for 4 seconds after lighting the flame. Fig. 15.

Turn the corresponding control knob clockwise to the 0

setting.

The progressive control knobs can be used to control the

power needed, from minimum to maximum power.

Setting

™

Large flame

Economy

flame

For double-flame burners, the inner and outer flames

can be controlled separately.

The available power levels are as follows:

Inner and outer flame on full power.

Control off

Maximum capacity

or aperture and

electricity on

Minimum capacity

or aperture