- ページ 6

ホブ Siemens EC8**SF SERIESのPDF 取扱説明書をオンラインで閲覧またはダウンロードできます。Siemens EC8**SF SERIES 35 ページ。

ページを印刷する

Switching on

Switching on a burner:

Turn on the appliance with the main switch. The main switch

indicator will be turned on.

Press and turn the desired burner control knob anticlockwise

to the required setting. The flame will ignite automatically and

the hotplate indicator light will come on after a few seconds.

If the burner does not switch on, wait at least a minute until

trying again.

Note: If after pressing the main switch, no burner comes on, the

appliance will automatically switch off after three minutes.

Safety system

All the hotplates have a security device (thermocouple).

If the burner is switched off during operation (e.g. due to a

draught), the appliance automatically switches on the hotplate

again.

If reignition is not successful (e.g. due to food remains on the

burner), the supply of gas to this burner is cut off and the

burner hotplate indicator flashes. Turn the control knob to 0

and check the section on Operating indicators and error

messages.

Switching off

Switching off a burner: turn the control knob clockwise to the off

setting.

Switching off the hob: after finishing cooking, turn all the

controls to setting 0 and turn off the appliance with the main

switch. The main switch indicator will be turned off.

Automatic off

After six hours of operation, the appliance switches off

automatically. Turn all control knobs to setting 0; the appliance

can now be switched on again.

Power levels

The progressive control knobs can be used to control the

power needed, from minimum to maximum power.

Setting

Control knob off

High flame

™

Maximum capacity or aperture and

electricity on

Low flame

Minimum capacity or aperture

For dual double-flame burners, the inner and outer flames can

be controlled separately. The available power levels are as

follows:

Operating and residual heat indicator

All the hotplates have an operating and residual heat indicator

which comes on when the flame on the corresponding hotplate

is lit.

Once the hotplate is switched off, the residual heat indicator

remains on indicating that the hotplate temperature is too high.

Do not touch the hotplate while the indicator light is on.

After a while the residual heat indicator will go off, indicating

that the temperature of the hotplate has dropped and is no

longer too high. Care must then be taken when touching the

appliance to avoid burns, since the hotplate may not have

completely cooled down.

Protection against overheating

The hob has an overheating protection system to protect the

electronics. This system switches off all the burners in case of

overheating, with the operating indicators of all the burners and

main switch starting to flash.

Turn all control knobs to setting 0. Wait until the appliance has

cooled down sufficiently and the main switch operating

indicator has turned off. Now you can reconnect the appliance

normally. The rapid flickering of the burner operating indicators

switches off or is replaced by the residual heat indicator.

Childproof lock

Activating the childproof lock:

Press the main switch for several seconds until the childproof

lock indicator comes on

on.

Deactivating the childproof lock:

Press the main switch for several seconds until the main switch

indicator comes on

. Now the hob can be switched on

normally.

Inner and outer flame on full

power.

Outer flame on minimum, inner

flame on full power.

Inner flame on full power.

Inner flame on minimum

power.

. Now the hob cannot be switched