Headset
Headset
Your phone supports four- or six-wire headset jacks for wired headsets. Cisco Unified IP Phones 7962G and
7942G also support wireless headsets. For information about purchasing headsets, see
Headsets.
You can use a headset with all of the controls on your phone, including
However, if you use a wireless headset, refer to the wireless headset documentation for instructions.
If you want to...
Toggle headset mode on and off
Switch to a handset
Adjust the volume level for a call
If you use AutoAnswer, see
Your system administrator can set up your phone to record a conversation between you (on your headset), a
supervisor (on the phone handset), and your connected party.
Important Headset Safety Information
When you plug in your headset, lower the volume of the headset speaker before you put the headset on. If
you remember to lower the volume before you take the headset off, the volume will start lower when you
plug in your headset again.
Be aware of your surroundings. When you use your headset, it may block out important external sounds,
particularly in emergencies or in noisy environments. Don't use the headset while driving. Don't leave your
headset or headset cables in an area where people or pets can trip over them. Always supervise children who
are near your headset or headset cables.
Control Wired Headset Sidetone and Headset Send Gain
When you speak on a telephone using a headset, the sound picked up by the headset microphone can be sent
back through the headset speaker. This creates a low-level feedback, known as sidetone. The wired headsets
can result in sidetone and headset send gain. Different wired headsets require different sidetone and send gain
settings. You need to select the best sidetone and send gain level for the wired headset you use.
Handset, Headset, and Speakerphone
2
AutoAnswer with Headset or Speakerphone, on page
High Sound Pressure—Avoid listening to high volume levels for long periods to prevent
possible hearing damage.
Handset, Headset, and Speakerphone
Then...
Press
.
Lift the handset.
Press
during a call or after invoking a dial
tone.
Press Save to preserve the volume level for future
calls.
4.
Wired and Wireless
and
.
ページを印刷する