Using Cisco Unified IP Phones with Different Protocols
From Cisco Unified Communications Manager, choose Device > Phone > Add New to add a phone
Step 6
using an already created BAT phone template.
For detailed instructions about using BAT, refer to the Cisco Unified Communications Manager Bulk
Administration Guide. For more information on creation of BAT Phone Templates, see the Cisco Unified
Communications Manager Bulk Administration Guide,
Related Topics
•
•
•
Using Cisco Unified IP Phones with Different Protocols
The Cisco Unified IP Phone can operate with SCCP (Skinny Client Control Protocol) or SIP (Session
Initiation Protocol). You can convert a phone that is using one protocol for use with the other protocol.
This section includes these topics:
•
•
•
Converting a New Phone from SCCP to SIP
A new, unused phone is set for SCCP by default. To convert this phone to SIP, perform these steps:
Procedure
Take one of these actions:
Step 1
•
•
•
Refer to Cisco Unified Communications Manager Administration Guide for detailed information about
Cisco Unified Communications Manager configuration. For more information about BAT, see Cisco
Unified Communications Manager Bulk Administration Guide.
If you are not using DHCP in your network, configure the network parameters for the phone.
Step 2
See
Save the configuration updates, click Apply Config, click OK when the Apply Configuration
Step 3
Information dialog displays, then have the user power cycle the phone.
Cisco Unified IP Phone Administration Guide for Cisco Unified Communications Manager 8.5
2-14
Adding Phones with Auto-Registration, page 2-11
Adding Phones with Auto-Registration and TAPS, page 2-12
Adding Phones with Cisco Unified Communications Manager Administration, page 2-13
Converting a New Phone from SCCP to SIP, page 2-14
Converting an In-Use Phone from One Protocol to the Other Protocol, page 2-15
Deploying a Phone in an SCCP and SIP Environment, page 2-15
To auto-register the phone, set the Auto Registration Phone Protocol parameter in Cisco Unified
Communications Manager Administration to SIP.
To provision the phone using the Bulk Administration Tool (BAT), choose the appropriate phone
model and choose SIP from the BAT.
To provision the phone manually, make the appropriate changes for SIP on the Phone configuration
window in Cisco Unified Communications Manager Administration.
Configuring Startup Network Settings, page
Chapter 2
Preparing to Install the Cisco Unified IP Phone on Your Network
Phone
Template.
3-15.
OL-23092-01
ページを印刷する