- ページ 10

オール・イン・ワン・プリンター Ricoh Ri 100のPDF 安全情報マニュアルをオンラインで閲覧またはダウンロードできます。Ricoh Ri 100 24 ページ。 Direct to garment (dtg) printer
Ricoh Ri 100 にも：備考 (12 ページ), メンテナンス・マニュアル (12 ページ), クイックマニュアル (4 ページ), クイック・インストール・マニュアル (4 ページ), クイックマニュアル (4 ページ), クイック・インストール・マニュアル (23 ページ), ご利用上の注意 (32 ページ)

2. Safety Information for This Machine

• Be sure to disconnect the plug from the wall outlet at least once a year and check for the

following:

• There are burn marks on the plug.

• The prongs on the plug are deformed.

• If any of the above conditions exist, do not use the plug and consult your dealer or service

representative. Use of the plug could result in fire or electric shock.

• Be sure to disconnect the power cord from the wall outlet at least once a year and check for the

following:

• The power cord's inner wires are exposed, broken, etc.

• The power cord's coating has a crack or dent.

• When bending the power cord, the power turns off and on.

• Part of the power cord becomes hot.

• The power cord is damaged.

• If any of the above conditions exist, do not use the power cord and consult your dealer or

service representative. Use of the power cord could result in fire or electric shock.

• When disconnecting the power cord from the wall outlet, always pull the plug, not the cord.

Pulling the cord can damage the power cord. Use of damaged power cords could result in fire

or electric shock.

• Be sure to push the plug of the power cord fully into the wall outlet. Partially inserted plugs

create an unstable connection that can result in unsafe buildup of heat.

• Be sure to disconnect the plug from the wall outlet and clean the prongs and the area around

the prongs at least once a year. Allowing dust to build up on the plug constitutes a fire hazard.

• If this machine is not going to be used for several days or longer at a time, disconnect its power

cord from the wall outlet.

• When performing maintenance on the machine, always disconnect the power cord from the

wall outlet.

• Rating voltage of the connector for option: Max. DC 37 V.