- ページ 4

IP電話 Cisco SPA504のPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco SPA504 8 ページ。 Digital office technology
Cisco SPA504 にも：セットアップ＆ユーザーマニュアル (8 ページ), ユーザーマニュアル (20 ページ), ユーザーマニュアル (7 ページ)

ページを印刷する

CHAPTER 2 INSTALLING CISCO SPA502 OR CISCO SPA504

Connecting your phone

Turn your phone over to expose the ports on the back of the

unit

Back of Phone

DC5V Power

plug

Insert one end of the 'curly' phone cable into the port marked

'HAC' on the back of the phone

Insert the other end of the 'curly' phone cable into the port at

the bottom of the handset

Connect the phone stand by lining up the tabs on the stand

with the slots on the phone body. Slide the bottom tabs into

the lower slots on the phone body and lightly press down on

the stand

Connect your phone to the network. Insert one end of the

Ethernet cable into the 'SW' LAN port on the back of the

phone. Insert the other end of the network cable into any

available Ethernet LAN (10/100) port on the router.

To provide network access to a PC and reduce the number

of Ethernet cables connected to the router, connect one end

of an additional Ethernet cable (not provided) to the port

marked "PC" on the back of the phone. Connect the other

end of the Ethernet cable to the network port on your

PC/computer.

Connect one end of the power cord into the power socket at

the back of the phone. Make sure the power source is

switched OFF, and then connect the other end of the power

cord into the power socket. Switch the power source ON.

After a few moments a small phone icon will be displayed on

the top right hand corner of the phone's LCD screen. (figure

PC port

Now you are ready to set-up your user profile.

LAN

Setting up your profile

Handset

The user profile must be set-up before you can use the

phone.

'login' will be displayed at the bottom left hand corner of the

LCD screen

Press the soft key beneath 'login' to select 'login' (figure 1)

Enter the Device ID and Password (obtain this information

from the Configuration Summary email received from Telstra)

using the number pad. Press the ok soft key (figure 2)

The phone will restart by itself and a 'Ready' message will

appear. The phone is now ready for use. (figure 3)

Figure 1: Initial screen

Figure 2: UserID and Password entry

Figure 3: Ready to use