- ページ 4
コントローラー ActronAir LM24-2GのPDF 取付説明書をオンラインで閲覧またはダウンロードできます。ActronAir LM24-2G 8 ページ。 Wall controller
ページを印刷するInstallation Guide
3. Mount back cover to the wall
• Mount the back cover to the wall with screws via screw
holes. If required, the use of a plasterboard mounting
bracket is recommended to mount the back cover to the
wall.
• Ensure that the Control Interface back cover is aligned
and leveled on the wall before tightening the screws.
BACK COVER
PLASTERBOARD
MOUNTING BRACKET
SCREW HOLES
5. Attach PCB casing to the back cover
• Attach the PCB casing by aligning with the back cover
mounted on the wall.
• Ensure the PCB casing makes a 'click' sound after
mounting.
BACK COVER
7. Assign and attach zones
• Attach the desired zone buttons and assign names to
each zone.
• Ensure the buttons make a 'click' sound when attached
to the PCB casing.
PCB CASING
1
2
3
4
5
BACK COVER
NOTE
Front cover can be removed even after installation. Press at
the bottom of the control interface and pull the front cover.
04
1
2
3
4
5
PCB CASING
ZONE BUTTONS
LM7-LM24 Control Interface Insert
Doc. No. 9590-3025 Ver. 2 220907
LM7-LM24 Control Interface
4. Connect wiring at the back of Control Interface
• Ensure that all wiring is tightly connected. All wiring must
be in accordance with the provided wiring diagram.
DO NOT CONNECT TRACE WIRE TO
WALL CONTROLLER.
CUT WIRE TO PREVENT SHORTING OUT.
6. Select zone buttons
• Remove the relevant zone buttons for zone name to be
allocated
8. Attach the front cover, as shown in the diagram below
IMPORTANT
Ensure protective film is removed from inside of the front
cover before attaching.
• On completion of the mounting installation, check that the
Control Interface is aligned and leveled on the wall.
1
2
3
4
5
BACK COVER
AS MOUNTED
ON THE WALL
SENSOR
KEY
COMMON
POWER
BUTTON PAD
FRONT COVER