- ページ 20
プロジェクター Ricoh PJ X4241NのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Ricoh PJ X4241N 28 ページ。
Ricoh PJ X4241N にも: ユーザーマニュアル (24 ページ), ご利用上の注意 (2 ページ)
2. Information for This Machine
Model Number:
• RICOH PJ X3351N
• RICOH PJ WX3351N
• RICOH PJ WX4241N
WLAN Module Name: LBWB1ZZWU6
Note:
This equipment has been tested and found to comply with the limits for a Class B digital device,
pursuant to Part 15 of the FCC Rules. These limits are designed to provide reasonable protection
against harmful interference in a residential installation. This equipment generates, uses and can
radiate radio frequency energy and, if not installed and used in accordance with the instructions,
may cause harmful interference to radio communications. However, there is no guarantee that
interference will not occur in a particular installation. If this equipment does cause harmful
interference to radio or television reception, which can be determined by turning the equipment off
and on, the user is encouraged to try to correct the interference by one or more of the following
measures:
• Reorient or relocate the receiving antenna.
• Increase the separation between the equipment and receiver.
• Connect the equipment into an outlet on a circuit different from that to which the receiver is
connected.
• Consult the dealer or an experienced radio /TV technician for help.
Note to users:
This equipment may only be operated indoors. Operation outdoors is in violation of 47 U.S.C. 301
and could subject the operator to serious legal penalties.
Caution:
Changes or modifications not expressly approved by the party responsible for compliance could
void the user's authority to operate the equipment.
This equipment complies with FCC radiation exposure limits set forth for an uncontrolled environment
and meets the FCC radio frequency (RF) Exposure Guidelines. This equipment has very low levels of RF
energy that it deemed to comply without maximum permissive exposure evaluation (MPE). But it is
desirable that it should be installed and operated keeping the radiator at least 20cm or more away from
person's body (excluding extremities: hands, wrists, feet and ankles).
5.15-5.35GHz band is restricted to indoor operations only.
Compliance with FCC requirement 15.407(c) Data transmission is always initiated by software, which is
the passed down through the MAC, through the digital and analog baseband, and finally to the RF chip.
Several special packets are initiated by the MAC. These are the only ways the digital baseband portion
will turn on the RF transmitter, which it then turns off at the end of the packet. Therefore, the transmitter
will be on only while one of the aforementioned packets is being transmitted. In other words, this device
18