- ページ 36
ネットワーク・ルーター Cisco 10008のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 10008 49 ページ。 Cisco systems router quick start guide
ページを印刷する
7
Configuring the Cisco 10008 Router at Startup
This section explains how to create a basic running configuration for your Cisco 10008 router using the Cisco 10008 setup
facility or the Cisco IOS command-line interface (CLI). For information on modifying the configuration after you create it, see
the online
Cisco 10000 Series Routers Documentation Roadmap
help you configure the Cisco 10008 router.
To configure a Cisco 10008 router from the console, you must connect a terminal or terminal server to the router' console port.
To configure the Cisco 10008 router over your Ethernet network management, you must have the router's IP address available.
Startup Display
When you power on your Cisco 10008 router or execute the reload command, the console screen displays a message similar to
the following:
Restricted Rights Legend
Use, duplication, or disclosure by the Government is
subject to restrictions as set forth in subparagraph
(c) of the Commercial Computer Software - Restricted
Rights clause at FAR sec. 52.227-19 and subparagraph
(c) (1) (ii) of the Rights in Technical Data and Computer
Software clause at DFARS sec. 252.227-7013.
cisco Systems, Inc.
170 West Tasman Drive
San Jose, California 95134-1706
Cisco Internetwork Operating System Software
IOS (tm) 10008 Software (C10K-P6-M), Experimental Version 12.0(20000413:055718)
[20000413:010004 104]
Copyright (c) 1986-2000 by cisco Systems, Inc.
Compiled Thu 13-Apr-00 04:20 by biff
Image text-base: 0x60008900, data-base: 0x60A6E000
cisco C10008 (CRE-RP) processor with 114688K/16384K bytes of memory.
Processor board ID 00018655341
R7000 CPU at 262Mhz, Implementation 39, Rev 1.0, 256KB L2, 2048KB L3 Cache
Unknown midplane, Version 1.0
Last reset from register reset
Toaster processor tmc0 is running.
Toaster processor tmc1 is running.
1 Ethernet/IEEE 802.3 interface(s)
1 FastEthernet/IEEE 802.3 interface(s)
509K bytes of non-volatile configuration memory.
40960K bytes of ATA PCMCIA card at slot 0 (Sector size 512 bytes).
32768K bytes of Flash internal SIMM (Sector size 256KB).
Press RETURN to get started!
Basic Configuration Using the Setup Facility
The first time you power on a Cisco 10008 router, the setup facility starts. You can also initiate the setup facility by running the
setup command in privileged EXEC mode. This facility helps you enhance a default configuration that already exists on the
Cisco 10008 router. The setup facility uses a question-and-answer sequence called the System Configuration Dialog to walk you
through configuring the router.
You do not have to configure the interfaces immediately; however, you cannot enable the interfaces or connect them to any
networks until you have configured them.
36
document for links to a complete listing of documents that will