- ページ 33
ネットワーク・ルーター Cisco 12406 seriesのPDF 交換取扱説明書をオンラインで閲覧またはダウンロードできます。Cisco 12406 series 44 ページ。 Chassis replacement instructions
Cisco 12406 series にも： 開梱取扱説明書 (16 ページ), データシート (9 ページ)
ページを印刷するFigure 19
1
2
3
Step 6
Visually check the LEDs on the two alarm cards. (See
correctly, the following LED conditions should be true.
LEDs that normally should be off:
•
•
•
•
LEDs that normally should be on:
•
•
•
Step 7
On the console terminal, verify that the console displays the system banner and that the system and all
interfaces initialize successfully.
If the power modules do not power up, or if the system or any interfaces do not initialize properly, see
Chapter 4, "Troubleshooting the Installation" in the Cisco 12006 and Cisco 12406 Router Installation
and Configuration Guide. If you are still unable to resolve the problem, contact your Cisco service
representative for assistance.
Packaging the Replaced Chassis for Shipment
To repackage the chassis to return it to the factory, follow these steps:
Use the anchor clips, angle brackets, bolts, and screws you removed when you unpacked the replacement
Step 1
chassis to fasten the defective chassis to the shipping pallet base. (See
78-16109-01
Alarm Card LEDs On/Off Conditions
FAIL
ENABLED
0
1
0
1
2
1
2
3
MBus status LED
CSC status LEDs (two)
SFC status LEDs (three)
One MBUS status LED labeled FAIL
Two CSC status LEDs labeled FAIL
Three SFC status LEDs labeled FAIL
Three router alarm LEDs labeled CRITICAL, MAJOR, MINOR
One MBUS status LED labeled ENABLED
Two CSC status LEDs labeled ENABLED
Three SFC status LEDs labeled ENABLED
ALARM
4
5 6
4
Critical alarm LED
5
Major alarm LED
6
Minor alarm LED
Figure
Cisco 12006 and Cisco 12406 Router Chassis Replacement Instructions
19.) When the system is operating
Figure
1.)
33