•
Cisco 6400 UAC−NRP IOS Software Release 12.1(3)DC1
•
Cisco 6400 UAC−NSP IOS Software Release 12.1(3)DB
•
Cisco 6130 DSLAM−NI2 IOS Software Release 12.1(5)DA
Components Used
The information in this document is based on these software and hardware versions.
To support the ADSL WIC on the Cisco 2600 or 3600, these hardware components are required:
•
2600: Chassis WIC slots, NM−2W
•
3600: NM−1FE1R2W, NM−1FE2W, NM−2FE2W, NM−2W
Note: For the Cisco 3600, ADSL is not supported on WIC NM−1E1R2W, NM−1E2W, or NM−2E2W.
These are the minimum Cisco IOS Software Releases required to support the ADSL WIC:
•
Cisco IOS Software Release 12.1(5)YB (Plus versions only) on the Cisco 2600 or 3600
•
Cisco IOS Software Release IOS 12.1(3)XJ or later (Plus versions or ADSL feature set only) on the
Cisco 1700. The ADSL feature set is identified by "y7" in the image name; for example,
c1700−sy7−mz.121−3.XJ.bin.
Note: When you download the image for the Cisco 1700, make sure you select the image name of 1700. Do
not download a 1720 or a 1750 image; the features do not support the ADSL WIC.
The information presented in this document was created from devices in a specific lab environment. All of the
devices used in this document started with a cleared (default) configuration. If you are in a live network,
ensure that you understand the potential impact of any command before you use use it.
Conventions
For more information on document conventions, see the Cisco Technical Tips Conventions.
Configure
In this section, you are presented with the information to configure the features described in this document.
Note: To find additional information on the commands used in this document, use the Command Lookup
Tool (registered customers only) .
Network Diagram
This document uses the network setup shown in the diagram below.
ページを印刷する