- ページ 37

ネットワーク・ルーター Cisco 1700 seriesのPDF ハードウェア・インストール・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1700 series 46 ページ。 Secure firewall management center
Cisco 1700 series にも：規制遵守と安全情報マニュアル (45 ページ), マニュアル (15 ページ), 設定マニュアル (25 ページ), アプリケーションノート (41 ページ), ハードウェアのトラブルシューティング (12 ページ), 概要マニュアル (13 ページ), 設定 (34 ページ), マニュアル (5 ページ), クイック・スタート・マニュアル (6 ページ)

Rack-Mount the Chassis

b) Set the keyed slots over the pegs, and then slide the rail toward the front to lock it in place on the pegs. The front slot

has a metal clip that locks over the front peg.

c) Install the second inner rail to the opposite side of the chassis.

Figure 31: Attach the Inner Rail to Side of Chassis

Front of chassis

Step 2

Open the front securing plate on both slide-rail assemblies. The front end of the slide-rail assembly has a spring-loaded

securing plate that must be open before you can insert the mounting pegs into the rack-post holes.

On the outside of the assembly, push the green arrow button toward the rear to open the securing plate.

Figure 32: Front Securing Mechanism, Inside of Front End

Front mounting pegs

Securing plate shown pulled back to open position

Step 3

Install the slide rails into the rack:

a) Align one slide-rail assembly front end with the front rack-post holes that you want to use.

The slide rail front end wraps around the outside of the rack post and the mounting pegs enter the rack-post holes

from the outside-front.

Note

b) Push the mounting pegs into the rack-post holes from the outside-front.

c) Press the securing plate release button, labeled PUSH. The spring-loaded securing plate closes to lock the pegs in

place.

The rack post must be between the mounting pegs and the open securing plate.

Cisco Secure Firewall Management Center 1700, 2700, and 4700 Hardware Installation Guide

Locking clip on inner rail

Rack post

Rack-Mount the Chassis