- ページ 4

ネットワーク・ルーター Cisco 1710のPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1710 13 ページ。 Security access routers
Cisco 1710 にも：データシート (11 ページ)

ページを印刷する

Figure 1

Installing the Router

C is c o

1 7 1 0

F D X

C O N

L IN K

S O LE

10 B T

E TH

E R N

F D X

E T

1 0 0

L N K

10 /1 00

E TH

E R N

E T

A U X

10/100

Ethernet

port

A U I

Straight-through

Ethernet cable

Always connect the Ethernet cable to the Ethernet ports on the router. Accidentally connecting the cable to the

Caution

wrong port can damage your router.

Connect one end of a second Ethernet cable to the 10BT ETHERNET port on the router (the port on the left).

Step 3

Connect the other end to your Internet modem.

Step 4

The 10BT ETHERNET port does not perform autosensing for full-/half-duplex operation, and the default setting is for

Note

half-duplex. To enable full-duplex mode on the 10BT ETHERNET port, you will need to use the Cisco IOS software

to reconfigure the port.

Configure the Router Using Cisco Router and Security Device Manager

Cisco Router and Security Device Manager (SDM) is a web-based configuration tool that allows you to configure LAN

and WAN interfaces, routing, Network Address Translation (NAT), firewalls, VPNs, and other features on your router.

If SDM is installed on your router, configure the router by following the instructions in the Cisco Router and Security

Device Manager (SDM) Quick Start Guide. If this document was not shipped with your router, you can obtain SDM and

instructions for installing it on your router from the following location:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM release notes, and other SDM documentation, go to http://www.cisco.com/go/sdm and click the Technical

Documentation link.

M O D

O K

Ethernet hub or switch