- ページ 21

ネットワーク・ルーター Cisco 1841 - 1841 Integrated Services RouterのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1841 - 1841 Integrated Services Router 28 ページ。 Integrated services router (modular)

ページを印刷する

end

Step 11 Respond to the following prompts. Select [2] to save the initial configuration.

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started! RETURN

The user prompt is displayed.

Router>

Step 12 Verify the initial configuration. See the "Verify the Initial Configuration" section on page 22 for verification procedures.

Initial Configuration Using Cisco CLI—Manual Configuration

This section shows how to display a command-line interface (CLI) prompt for configuration using the CLI, and it directs you

to documentation for the CLI configuration. You can use the CLI if the following messages appear at the end of the startup

sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file were installed on the router at the factory. To use SDM

to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager" section on page 18.

For help with interface and port numbering, see the "Interface Numbering" section on page 17.

Step 1

To proceed with manual configuration using the CLI, enter no when the power-up messages end:

Would you like to enter the initial configuration dialog? [yes/no]: no

Step 2

Press Return to terminate autoinstall and continue with manual configuration:

Would you like to terminate autoinstall? [yes] Return

Several messages appear, ending with a line similar to the following:

Compiled < date > < time > by < person >

Step 3

Press Return to display the Router> prompt:

...

flashfs[4]: Initialization complete.

Router>

Step 4

Enter privileged EXEC mode:

Router> enable

Router#

Step 5

For configuration procedures, refer to the applicable configuration instructions in the Cisco 2800 series software

configuration documents. See the "Where to Go Next" section on page 22 for information about accessing these

documents.