- ページ 6

ネットワーク・ルーター Cisco 1861 SeriesのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1861 Series 9 ページ。 1800 series
Cisco 1861 Series にも：データシート (20 ページ)

ページを印刷する

Initial Configuration of the Router

•

Cisco Router and Security Device Manager

If the Cisco Router and Security Device Manager (SDM) has been installed on your router, the following

messages appear at the end of the startup sequence:

yourname con0 is now available

Press RETURN to get started.

For instructions on configuring your router by using SDM, see the

Manager (SDM) Quick Start

instructions for installing it on your router:

http://www.cisco.com/pcgi-bin/tablebuild.pl/sdm

To obtain the SDM quick start guide, SDM release notes, and other SDM documentation, go to

www.cisco.com/go/sdm.

Verifying the Initial Configuration

Verify that the new interfaces are operating correctly by performing the following tests:

•

When you have completed and verified the initial configuration, your Cisco router is ready to be

configured for specific functions. See the

information about locating documentation for advanced configuration procedures.

Completing the Configuration

When you have completed and verified the initial configuration, your Cisco router is ready to be

configured for specific functions. For advanced configuration procedures, use either SDM or the CLI.

For configuration procedures using SDM, see

Start

For configuration procedures using the CLI, see

software configuration documents include information about the following topics:

•

Cisco 1800 Series Routers (Modular) Hardware Installation Guide

7-6

Cisco Router and Security Device Manager—See the

section on page 7-6

Setup command facility—See the

in the

Cisco 1800 Series Integrated Services Routers (Modular) Quick Start Guide.

Command-line interface (CLI)—See the

Configuration"

section in the

Guide.

Guide. To use SDM, you can download the latest version of SDM and

Enter the show interfaces command to verify that the interfaces are operating correctly and that the

interfaces and line protocol are in the correct state—up or down.

Enter the show ip interface brief command to display a summary status of the interfaces configured

for IP.

Enter the show configuration command to verify that you configured the correct hostname and

password.

Guide.

Basic software configuration

Chapter 7

Power-Up Procedures for Cisco 1800 Series Routers (Modular)

"Cisco Router and Security Device Manager"

"Initial Configuration Using the Setup Command Facility"

"Initial Configuration Using Cisco CLI—Manual

Cisco 1800 Series Integrated Services Routers (Modular) Quick Start

"Completing the Configuration" section on page 7-6

Cisco Router and Security Device Manager (SDM) Quick

Cisco 1800 Series Router Software

Cisco Router and Security Device

Configuration. The

OL-5876-03

section

for