- ページ 15
ネットワーク・ルーター Cisco 2500 SeriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2500 Series 19 ページ。 Wireless controller
Cisco 2500 Series にも： 設置マニュアル (12 ページ), 配備マニュアル (23 ページ), 設定マニュアル (50 ページ), スタートマニュアル (47 ページ)
ページを印刷する
Step 3
Configuring the Synchronous Serial Interfaces
The synchronous serial interfaces are configured to allow connection to WANs through a
CSU/DSU. Once the Ethernet or Token Ring port on your access server has been
configured, take the following steps to configure the serial port:
Step 1
Step 2
Step 3
Determine if you are going to enable IPX on this interface, enter the unique IPX
network number. See the appendix "Internetworking Primer" for additional
information on IPX routing:
Configure IPX on this interface? [no]: yes
IPX network number [1]: B001
Configure XNS on this interface? [no]
Enter yes to configure serial port 0:
Configuring interface Serial0:
Is this interface in use? [no]: yes
Determine what protocols you will allow on the synchronous serial interface and
enter the appropriate responses:
Configure IP unnumbered on this interface? [no]: no
IP address for this interface: 172.16.73.1
Number of bits in subnet field [8]:
Class B network is 172.16.0.0, 8 subnet bits; mask is 255.255.255.0
Configure AppleTalk on this interface? [no]: yes
Extended AppleTalk network? [yes]:
AppleTalk starting cable range [2]: 3
AppleTalk ending cable range [3]: 3
AppleTalk zone name [myzone]: ZZ Serial
AppleTalk additional zone name:
Configure IPX on this interface? [no]: yes
IPX network number [2]: B000
Configure the second synchronous serial interface as follows:
Configuring interface Serial1:
Is this interface in use? [no]:
Configuring the Cisco 2500 Series Access Server 4-15
Configuring the Access Server