- ページ 4
プロジェクター Epson EMP-715 - XGA LCD ProjectorのPDF 製品情報をオンラインで閲覧またはダウンロードできます。Epson EMP-715 - XGA LCD Projector 13 ページ。 Epson powerlite 505c: product information
Epson EMP-715 - XGA LCD Projector にも： 仕様 (3 ページ)
ページを印刷するEPSON PowerLite 505c/715c Projector
3. Use the tab on the lens ring to rotate the ring and extend the
lens.
4. Squeeze the lens cap tabs and remove the lens cap.
Caution: Do not use the projector with the lens cap in place.
The heat generated by the lens can damage the cap.
Power
5. Press the red
button on top of the projector.
Power
button
The power light flashes green as the projector warms up, and
the projection lamp comes on in about 30 seconds. The
power light stays green.
You may see the EasyMP
that has been saved on the memory card and set to run
automatically.
Warning: never look into the lens when the lamp is on. This
can damage your eyes, and is especially dangerous for children.
EPSON PowerLite 505c/715c Projector
4 -
tab
Squeeze here
power light
main screen or a presentation
™
6. Do one of the following:
❏ If you're presenting without a computer, you may see the
EasyMP main screen. Use the
remote control to select your presentation, then press
Enter
to start it. See the
If a presentation starts automatically, you may need to
Enter
press
to change slides.
❏ If you're using a computer, turn it on or restart it. In a
few moments, you should see your computer display
projected. If you see an EasyMP screen or presentation
instead, press the
to switch to the computer.
(Windows
only: If you see a message saying that it has
®
found a plug-and-play monitor, click
❏ If you're projecting a video, press the
top of the projector to switch to your video source, and
Play
press the
button on your DVD player or other video
device.
If a projected image fails to appear, see the next section for
help.
Once you see your image, turn to page 5 for instructions on
focusing and making other image adjustments.
When you're done with your presentation, shut down the
projector as described on page 6. Shutting down the projector
correctly prevents premature lamp failure and possible damage
from overheating.
What To Do If You See a Blank Screen
If you see a blank screen or a blue screen with the message
Signal
after turning on your computer or video source, try the
following:
❏ Make sure the cables are connected correctly, as described in
the
.
User's Guide
❏ Make sure the power light is green and not flashing and the
lens cap is off.
❏ Try restarting your computer.
❏ Press the
Source
button on top of the projector to select the
correct source. (Allow a few seconds for the projector to sync
up after pressing the button.)
1/01
Enter
button on the
for more information.
User's Guide
Source
button on top of the projector
Cancel.
Source
)
button on
No