- ページ 12

ネットワーク・ルーター Cisco 2524 - Router - ENのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2524 - Router - EN 23 ページ。 Troubleshooting guide
Cisco 2524 - Router - EN にも：設定マニュアル (23 ページ), 概要 (10 ページ), インストールの準備 (19 ページ), トラブルシューティングマニュアル (4 ページ)

ページを印刷する

Configuring the Router

Step 2

Step 3

Configuring the Synchronous Serial Interfaces

The synchronous serial interfaces are configured to allow connection to WANs. Once the

Ethernet or Token Ting port on your router has been configured, take the following steps to

configure the synchronous serial interfaces:

Step 1

Step 2

4-12 Cisco 2524 and Cisco 2525 Router User Guide

Enter yes if you will be using AppleTalk on the interface. Enter yes to configure

the router for extended AppleTalk networks, and then enter the cable range. Enter

the zone name, and any other additional zones that will be associated with your

local zone:

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [no]: yes

AppleTalk starting cable range [0]: 3

AppleTalk ending cable range [1]: 3

AppleTalk zone name [myzone]:

AppleTalk additional zone name: otherzone

AppleTalk additional zone name:

Determine if you are going to enable IPX on the interface. If so, enter yes and then

enter the unique IPX network number:

Configure IPX on this interface? [no]: yes

IPX network number [1]: B001

Press Return or enter yes to configure serial port 0:

Configuring interface Serial0:

Is this interface in use? [yes]:

Determine which protocols you want on the synchronous serial interface and enter

the appropriate responses. In this example, the system is being configured for IP,

AppleTalk, and IPX:

Configure IP on this interface? [yes]:

Configure IP unnumbered on this interface? [no]:

IP address for this interface: 172.16.73.1

Number of bits in subnet field [8]:

Class B network is 172.16.0.0, 8 subnet bits; mask is

255.255.255.0

Configure AppleTalk on this interface? [no]: yes

Extended AppleTalk network? [yes]:

AppleTalk starting cable range [2]: 4