- ページ 6

ネットワーク・ルーター Cisco 2600 SeriesのPDF インストレーション・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2600 Series 12 ページ。 Configuring adsl wic to support pppoe clients
Cisco 2600 Series にも：リリースノート (32 ページ), 構成 (15 ページ), アプリケーションノート (41 ページ), データシート (6 ページ), 付録 (15 ページ), インストレーション・マニュアル (22 ページ), 概要 (13 ページ), クイック・スタート・マニュアル (2 ページ), マニュアル (5 ページ)

Removing the Cover

Take these steps to remove the chassis cover:

Step 1

Step 2

Step 3

Warning

contact with telephone-network voltages.

Warning

lightning activity.

Step 4

Step 5

Figure 2

Step 6

Figure 3

Step 7

6 Installing the Cisco RPS Adapter Plate in Cisco 2600 Series Routers

Power OFF the router.

Attach an ESD-preventive wrist strap.

Disconnect all cables from the rear panel of the router.

Before opening the chassis, disconnect the telephone-network cables to avoid

Do not work on the system or connect or disconnect cables during periods of

Place the router so that the front panel is facing you. Remove the screws located on top

of the cover near the front edge.

Slide the cover away from you until the metal tabs on the side edges separate from the

chassis bottom, as shown in Figure 2.

Removing the Cover

POWER

RPS

ACTIVITY

Lift the front edge of the cover until it clears the front of the chassis, as shown in Figure 3.

Lifting the Cover

POWER

RPS

ACTIVITY

Lift the cover until it is free from the chassis and then set it aside.

Cisco 2600

SERIES

Cisco 2600

SERIES