- ページ 14

ネットワーク・ルーター Cisco 2600 SeriesのPDF 構成をオンラインで閲覧またはダウンロードできます。Cisco 2600 Series 15 ページ。 Configuring adsl wic to support pppoe clients
Cisco 2600 Series にも：インストレーション・マニュアル (12 ページ), リリースノート (32 ページ), アプリケーションノート (41 ページ), データシート (6 ページ), 付録 (15 ページ), インストレーション・マニュアル (22 ページ), 概要 (13 ページ), クイック・スタート・マニュアル (2 ページ), マニュアル (5 ページ)

3 Configure CEF

Load balancing is based on a combination of source and destination packet information;

it allows you to optimize resources by distributing traffic over multiple equal-cost

connections for transferring data to a destination. You configure load balancing on

outbound interfaces on a per-destination or per-packet basis.

To enable CEF, use the following command in global configuration mode:

Router(config)# ip cef

Per-destination load balancing is enabled by default when you enable CEF. Typically,

you would disable per-destination load balancing when you want to enable per-packet

load balancing. To disable per-destination load balancing, use the following command

in interface configuration mode:

Router (config-if) # no ip load-sharing per-destination

To enable per-packet load balancing, use the following command in interface

configuration mode:

Router (config-if) # ip load-sharing per-packet

Hash bucket accounting to collect statistics is better to understand Cisco Express

Forwarding patterns in your network. Use the following command to enable it:

Router (config) # ip cef accounting load-balance-hash

Use the use the following commands in privileged EXEC mode to view the path-to-

bucket assignment result from the hash bucket accounting

Router# show ip cef {prefix} internal