- ページ 8

ネットワーク・ルーター Cisco 2621XMのPDF オペレーションをオンラインで閲覧またはダウンロードできます。Cisco 2621XM 25 ページ。 Non-proprietary security policy
Cisco 2621XM にも：ユーザーマニュアル (20 ページ), ユーザーマニュアル (48 ページ)

ページを印刷する

The 2621XM/2651XM Router

•

User Services

A User enters the system by accessing the console port with a terminal program. The IOS prompts the

User for their password. If the password is correct, the User is allowed entry to the IOS executive

program. The services available to the User role consist of the following:

•

Physical Security

The router is entirely encased by a thick steel chassis. The rear of the unit provides 1 Network Module

slot, 2 WIC slots, on-board LAN connectors, Console/Auxiliary connectors, the power cable connection

and a power switch. The top portion of the chassis may be removed (see

motherboard, memory, and expansion slots.

Cisco 2621XM and Cisco 2651XM Modular Access Routers with AIM-VPN/EP FIPS 140-2 Non-Proprietary Security Policy

Define Rules and Filters—create packet Filters that are applied to User data streams on each

interface. Each Filter consists of a set of Rules, which define a set of packets to permit or deny based

characteristics such as protocol ID, addresses, ports, TCP connection establishment, or packet

direction.

Status Functions—view the router configuration, routing tables, active sessions, use Gets to view

SNMP MIB II statistics, health, temperature, memory status, voltage, packet statistics, review

accounting logs, and view physical interface status

Manage the router—log off users, shutdown or reload the outer, manually back up router

configurations, view complete configurations, manager user rights, and restore router

configurations.

Set Encryption/Bypass—set up the configuration tables for IP tunneling. Set keys and algorithms

to be used for each IP range or allow plaintext packets to be set from specified IP address.

Change Network Modules—insert and remove modules in the Network Module slot as described

in the

"Initial Setup"

section of this document.

Change WAN Interface Cards—insert and remove WICs in the WAN interface slot as described

in the

"Initial Setup"

section of this document.

Status Functions—view state of interfaces, state of layer 2 protocols, version of IOS currently

running

Network Functions—connect to other network devices through outgoing telnet, PPP, etc. and

initiate diagnostic network services (i.e., ping, mtrace)

Terminal Functions—adjust the terminal session (e.g., lock the terminal, adjust flow control)

Directory Services—display directory of files kept in flash memory

Figure

5) to allow access to the

OL-6262-01