- ページ 9

ネットワーク・ルーター Cisco 2654T6のPDF リパッキング・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 2654T6 26 ページ。 Cisco systems router owner's manual

Appendix A

Repackaging the Router

Removing Components from the Chassis to Reduce Weight

Removing Power Modules

OL-17440-01

If your router is equipped with the DC-input power shelf, disconnect the eight

source DC positive and negative power cables and the single ground cable from

the terminal studs on the back panel of the power shelf as instructed in the

"Removing and Installing a DC-Input Power Shelf" section on page

A fully-equipped router can weigh as much as 415 lb (188 kg). To reduce the

top-end weight of the chassis and lower the center of gravity, which might make

the chassis more stable as you move it, you may choose to remove some of the

components from the chassis.

Procedures in the following sections describe the steps for removing some of the

router components:

Removing Power Modules, page A-9

•

Removing the Blower Modules, page A-10

•

Removing the Cards from the Chassis Card Cages, page A-10

•

Each AC-input power supply weighs 12.7 lb (5.7 kg). By electing to remove the

three power supplies from the standard AC-input power shelf, you reduce the

top-end weight of the chassis by approximately 38.1 lb (17.1 kg). By electing to

remove the four power supplies from the optional AC-input power shelf, you

reduce the top-end weight of the chassis by approximately 50.8 lb (22.8kg)

Remove the AC-input power supplies as described in the

Power Supplies" section on page

Each DC-input power entry module weighs 6.4 lb (2.9 kg). By electing to remove

the four power entry modules from the power shelf, you reduce the top-end weight

of the chassis by approximately 25.6 lb (11.6 kg). Remove the DC-input power

entry modules as described in

page

3-12.

Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide

3-75.

the"Removing DC-Input PEMs" section on

Repackaging the Routers

5-54.

"Installing AC-Input

A-9