- ページ 8

ネットワーク・ルーター Cisco 2821 - Integrated Services Router Unified Communications BundleのPDF 構成をオンラインで閲覧またはダウンロードできます。Cisco 2821 - Integrated Services Router Unified Communications Bundle 10 ページ。 Overview
Cisco 2821 - Integrated Services Router Unified Communications Bundle にも：クイック・スタート・マニュアル (47 ページ), 概要 (27 ページ)

ページを印刷する

Cisco 2821 - Integrated Services Router Unified Communications Bundle 構成

Configuring the Router

Initial Configuration Using the Cisco CLI—Manual Configuration

This section shows how to display a command-line interface (CLI) prompt for configuration using the

CLI, and it directs you to documentation for the CLI configuration.You can use the CLI if you see the

following messages at the end of the startup sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file were installed on the router at the

factory. To use SDM to configure your router, see the

Security Device Manager" section on page

For help with interface and port numbering, refer to the

of Cisco 2800 Series Routers

To proceed with manual configuration using the CLI, enter no when the power-up messages end:

Step 1

Would you like to enter the initial configuration dialog? [yes/no]: no

Step 2

Press Return to terminate autoinstall and continue with manual configuration:

Would you like to terminate autoinstall? [yes] Return

Several messages are displayed, ending with a line similar to the following:

...

Compiled <date> <time> by <person>

Press Return to bring up the Router> prompt.

Step 3

...

flashfs[4]: Initialization complete.

Router>

Type enable to enter privileged EXEC mode:

Step 4

Router> enable

Router#

Step 5

For configuration procedures, refer to the online

documents.

Note

When you have finished the initial configuration, verify the initial configuration. See the

Step 6

Initial Configuration" section on page 9

Power Up and Initial Configuration Procedures for Cisco 2800 Series Routers

online document.

To avoid losing work you have completed, be sure to save your configuration occasionally as you

proceed. Use the copy running-config startup-config command to save the configuration to

NVRAM.

"Initial Configuration Using Cisco Router and

"Interface Numbering"

Cisco 2800 Series Software Configuration Guide

for verification procedures.

section of the

Overview

"Verifying the

OL-5788-01