- ページ 26

ネットワーク・ルーター Cisco 3700 seriesのPDF アップグレード手順をオンラインで閲覧またはダウンロードできます。Cisco 3700 series 30 ページ。 Siemens hipath 4000 release 1 and siemens hicom 330e release 3.1 to cisco ios voice gateway using e1 qsig with h.323
Cisco 3700 series にも：インストールとフォーマット (34 ページ), データシート (8 ページ), アプリケーションノート (41 ページ), インストレーション・マニュアル (12 ページ)

Upgrading System Memory in Cisco 3745 Routers

Figure 14

Reinstall the chassis on a rack or desktop.

Step 7

Proceed to the

Step 8

Replacing Connections to the Router

To make final connections to the router, follow these steps:

Replace all network connections.

Step 1

Do one of the following:

Step 2

•

Turn ON the power switch. The power LED on the front panel of the router should come on.

Step 3

Check the Sys LED on the right side of the front panel to verify that it goes on after a few seconds delay

Step 4

when booting.

If you have problems, see the

Step 5

Proceed to the

Step 6

Upgrading System Memory in Cisco 3700 Series Routers

Captive Screws on a Cisco 3745 Router

"Replacing Connections to the Router" section on page

AC-powered router: Plug the power cord into a 3-terminal, single-phase power source that

provides power within the acceptable range (100 to 240 VAC, 50 to 60 Hz).

DC-powered router: Remove the tape from the circuit breaker switch handle and reinstate power

by moving the handle of the circuit breaker to the ON position.

"Obtaining Technical Assistance" section on page

"Recovering Compact Flash Memory and System Images" section on page

26.

28.

27.

OL-5423-02