- ページ 14

ネットワーク・ルーター Cisco 4000 SeriesのPDF アップグレードマニュアルをオンラインで閲覧またはダウンロードできます。Cisco 4000 Series 24 ページ。 Upgrading memory
Cisco 4000 Series にも：マニュアル (18 ページ), インストールの準備 (11 ページ), インストレーション・マニュアル (18 ページ), 交換マニュアル (16 ページ)

ページを印刷する

Memory Replacement Procedures

Removing Main Memory SIMMs

Take the following steps to remove main memory SIMMs:

Step 1

Step 2

Caution

damaged by mishandling.

Step 3

Step 4

Step 5

Step 6

Proceed to the next section, "Installing Main Memory SIMMs."

Installing Main Memory SIMMs

Take the following steps to install main memory SIMMs:

Step 1

Step 2

Caution

damaged by mishandling.

Step 3

Step 4

Step 5

14 Upgrading Cisco 4500, Cisco 4500-M, Cisco 4700, and Cisco 4700-M Memory

Attach an ESD-preventive wrist strap and ensure that it makes good contact with your skin.

Connect the equipment end of the wrist strap to the metal back plate of the chassis, avoiding

contact with the connectors.

On the motherboard, locate the main memory SIMM card sockets shown in the upper right

of Figure 8.

Handle SIMMs by the card edges only. SIMMs are ESD-sensitive components and can be

Remove one SIMM at a time, beginning with the SIMM farthest from the edge of the

motherboard.

To lift the SIMM out of its socket, pull the locking spring clips on both sides outward and

tilt the SIMM free of the clips. (See Figure 11.)

Hold the SIMM by the edges with your thumb and index ﬁnger and lift it out of the socket.

Place the removed SIMM in an antistatic bag to protect it from ESD damage.

Repeat Step 2 through Step 5 for each main memory SIMM card.

Attach an ESD-preventive wrist strap and ensure that it makes good contact with your skin.

Connect the equipment end of the wrist strap to the metal back plate of the chassis, avoiding

contact with the connectors.

On the motherboard, locate the main memory SIMM card sockets shown in the upper right

of Figure 8. All the sockets should be empty. If they are not, follow the steps in the previous

section "Removing Main Memory SIMMs."

Handle SIMMs by the card edges only. SIMMs are ESD-sensitive components and can be

Hold the SIMM with the polarization notch on the right and the component side away from

you with the connector edge at the bottom. (See Figure 10.)

Beginning with the SIMM nearest the edge of the motherboard, insert the main memory

SIMM card at a 45-degree angle and rock it into its vertical position (see Figure 12), using

the minimum amount of force required. When the SIMM is properly seated, the socket

guide posts will insert through the alignment holes, and the locking springs will click into

place.

Ensure that each SIMM is straight and that the alignment holes (as shown in Figure 10) line

up with the plastic socket guides.