ネットワーク・ルーター Cisco 6160のPDF 取り付けと交換に関する注意事項をオンラインで閲覧またはダウンロードできます。Cisco 6160 18 ページ。 Without a pots splitter configuration
Cisco 6160 にも： クイック・リファレンス・マニュアル (38 ページ), ハードウェア・インストール・マニュアル (21 ページ), インストール手順マニュアル (32 ページ)
ページを印刷する
Cisco 6160 PEM FRU Installation and
Replacement Notes
Product Number: 6160-1-PEM-DC=
This document provides an overview of and installation and replacement procedures for the Cisco 6160
power entry module (PEM). The PEM is a field-replaceable unit (FRU) in the Cisco 6160 chassis.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Contents
This document includes the following sections:
Introduction, page 1
•
Part and Tool Requirements, page 4
•
•
•
•
Standards and Certifications, page 13
Related Documentation, page 14
•
Obtaining Documentation, page 14
•
•
Obtaining Technical Assistance, page 15
Introduction
The Cisco 6160 chassis is equipped with one or two -48VDC PEMs, which distribute direct current (DC)
power within the chassis. The Cisco 6160 needs only one active PEM to operate; if two PEMs are
installed, a secondary PEM serves as a hot backup to the first PEM.
Each PEM should be connected to a single DC power source. For full power redundancy, two PEMs must
be installed and connected to two separate DC power sources.
Corporate Headquarters:
Cisco Systems, Inc., 170 West Tasman Drive, San Jose, CA 95134-1706 USA
Copyright © 2002. Cisco Systems, Inc. All rights reserved.