- ページ 19
ネットワーク・ルーター Cisco 7000 and 7507 Chassis MAS-7507のPDF 交換取扱説明書をオンラインで閲覧またはダウンロードできます。Cisco 7000 and 7507 Chassis MAS-7507 48 ページ。 Cisco systems cisco 7000 and cisco 7507 chassis replacement instructions
ページを印刷するFailure to use the ejector levers could result in a partial backplane connection and subsequent system
crash. Also, be sure to tighten both the top and bottom captive installation screws on each module to
ensure that it will remain seated properly. When replacing components, work from right to left.
When you remove a processor module, immediately install it in the new chassis and secure it in the
identical slot before removing the next processor module. Before removing processor modules, first
remove the blank board carrier from the corresponding slot in the new chassis so that you can move
the processor module directly into the same slot in the new chassis.
Follow these steps to move the processor modules to the new chassis:
Step 1
Use a screwdriver (Number 2 Phillips or 1/4-inch flat-blade) to loosen the captive
installation screws at the top and bottom of the faceplate. (See Figure 8a).
Figure 8
Bottom Ejector Lever and Captive Installation Screw
a
Captive
installation
screw
b
Bottom ejector lever
Processor
module
carrier guide
Stop
immediately
on contact
Cisco 7000 and Cisco 7507 Chassis Replacement Instructions
Moving System Components
Processor module
slot
c
19