- ページ 15

ネットワーク・ルーター Cisco 7100 SeriesのPDF 設置マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 7100 Series 21 ページ。 Field-replaceable units in vpn routers
Cisco 7100 Series にも：クイック・スタート・マニュアル (25 ページ)

ページを印刷する

Replacing the Chassis Cover

This section describes replacing the chassis cover on the router. You must remove the chassis cover

to gain access to the SDRAM DIMMs.

To replace the chassis cover:

Step 1

Step 2

Step 3

Step 4

Step 5

Step 6

Figure 11

Place the chassis bottom so that the front panel is facing you.

Hold the chassis cover over the chassis bottom, and align each of the cover tabs with the

chassis tabs at the top rear of the chassis. (See Figure 11.)

Lower the front of the top cover to close the chassis, and ensure the following:

•

The chassis cover tabs fit under the edge of the chassis rear panel so that they are not

exposed.

•

The chassis tabs fit under the chassis cover so that they are not exposed.

•

The chassis cover side tabs on both sides fit inside the chassis side panels so that they

are not exposed.

When the chassis cover is properly assembled, no tabs are visible.

Secure the chassis cover with four screws.

Reinstall the chassis in the rack. (See the "Installing the Rack-Mount and

Cable-Management Brackets" section on page 8.)

Reinstall all interface cables.

Replacing the Chassis Cover

Chassis cover

C i s

Front panel

Installing Field-Replaceable Units in Cisco 7100 Series VPN Routers

Chassis

tabs

c o

7 1 0

S E

R I E

Replacing the Chassis Cover

Chassis bottom