- ページ 5

モビリティ・エイド C.T.M. HS-850のPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。C.T.M. HS-850 15 ページ。 Mobility scooter 8-series
C.T.M. HS-850 にも：取扱説明書 (17 ページ)

ページを印刷する

Trouble Shooting

3-1

Scooter won't move when key in turned on,

Check Point

Check if the power is off

Check if the N-D lever is in Neutral position

Check if the battery power is enough. (Battery

gauge is under 25%)

Check if the charger power cord is still plugged in

scooter

3-2

Error Code

Flash Description

Battery low

Low battery fault

High battery fault

Current limit time-out or

controller overheat

Park brake

Drive inhibit

Solution

Turn the power on.

Switch to D (drive) position. Turn off the power and

turn on again.

Recharge the battery and then retest.

Unplug the charger power cord.

Initial Check Points

The batteries are running low.

Recharge the batteries

The batteries have run out of charge

Recharge the batteries

Check the battery and associated connections and wiring.

Battery voltage is too high, this may occur if overcharged and/or

traveling down a long slope.

If traveling down a slope, reduce the speed to minimize the

amount of regenerative charging.

The motor has been exceeding its maximum current rating for too

long.

The scooter may have stalled. Turn the controller off, leave for a

few minutes and turn back on again.

The motor may be faulty. Check the motor and associated

connections and wiring.

Either a park brake release switch is active or the park brake is faulty.

Check the park brake and associated connections and wiring.

Ensure any associated switches are in their correct positions.

Either a stop function is active or charger inhibits or OONAPU

condition has occurred.

Release the stop condition (seat raised etc.)

Disconnect the battery charger.

Ensure the throttle is in Neutral when turning the controller on.

Service Manual- CTM HS-850