- ページ 2

アクセサリー Ace 3035748のPDF オーナーズマニュアルをオンラインで閲覧またはダウンロードできます。Ace 3035748 13 ページ。 Wireless chime accessory receiver

Note: Most installations will not require you to change any of the jumpers

on your chime and push button.

The push button and chime communicate by using a code that can be changed

by removing and/or adding jumpers on both the push button and chime. The

code is factory set; however, there are 128 selectable codes that allow you to

expand your system and prevent outside interference. Other wireless products

may cause interference and the system may not function properly. Follow the

instructions below for setting a new code.

1. Open the cases and locate jumpers on both the push button and chime (See

illustration on page 3).

2. The push button and chime both have eight different jumper locations. The

jumper positions 1 through 7 are used for setting the code.

3. To change the code, add and/or remove jumpers as needed. It is recom-

mended to only change one jumper at a time and then check to see if system

is functioning properly. Note: Jumpers in positions 1 through 7 must be exactly

the same for both the push button and chime for this system to function.

Your wireless chime has different selectable tunes: Ding (one note), Ding-Dong

(two note), or Westminster (eight note) (Available on selected chimes). The

factory setting is for the Ding-Dong tune (or Westminster, when available). This

tune can be changed by following the instructions below.

• Ding (one note tune)

Push Button: Add a jumper to location 8.

• Ding-Dong (two note tune)

Push Button: Remove jumper from location 8.

Chime: Remove jumper from location 8.

• Westminster (Eight note tune) (Available on selected chimes)

Push Button: Remove jumper from location 8.

Chime: Add a jumper to location 8.

Note: All models have both front and back door tune capabilities. You may pur-

chase any ACE

the back door use the Ding tune and the front door use the Ding-Dong tune

(or Westminster tune, available on selected chimes). Models that include two

push buttons will come factory set for front and back doors. Decals on the rear

of the push button will indicate its setting.

Code and Tune Settings

Code Settings

wireless push button for a second entrance. We recommend

Tune Settings

-2-

598-1075-03