- ページ 6

アンプ CAAS Audio EPreのPDF ユーザーマニュアルをオンラインで閲覧またはダウンロードできます。CAAS Audio EPre 10 ページ。 Elysian pre-amplifier

Important Precautions (Mandatory)

Water and moisture

The EPre should not be used near water. Care should be taken not to allow the EPre to fall into water or

other liquids and ensure that liquids are never spilled onto or into the EPre.

Power sources

The EPre voltage and current rating is indicated on the rear panel of the unit. This will state either 240Vac or

120Vac. Two T1A time-lag fuses are included for 120V versions and two T0.5A fuses are included for the

240V versions. The input frequency rating of the power supply is 50Hz to 60Hz. The EPre typically draws

less than 20W during the normal operation. Please verify that the indicated voltage requirement is consistent

with the mains voltage in your location.

Grounding

We provide a standard IEC AC mains cable that fits into the rear of the EPre. The EPre is equipped with an

earth ground provided by this cable and connection. DO NOT defeat this ground, the EPre should always be

grounded. It is dangerous to operate the EPre without a ground connection. Additionally the EPre may not

function correctly without a ground connection.

Power and Signal cables

The EPre is supplied with a power cable that meets UK legislated requirements. As with all audiophile

equipment the power cable should be the last item attached and the first item removed whenever equipment

is added or removed from the audio chain. Any cables (power or signal) should never be connected or

removed while the equipment or supporting equipment is powered up. Failure to pay attention to this

precaution may result in damaged equipment.

Ventilation

Audio equipment may run hot. The installation must allow for this heat dissipation. We recommend free air

circulation around the product. This can best be achieved by leaving at least a 20cm gap around the unit.

The EPre should not be installed or situated near any other source of heat (e.g. central heating radiator or on

top of an amplifier).

Servicing

To reduce the risk of fire, electrical shock or other injuries, the user should not attempt to service the EPre.

Please do not open the EPre. There are no user serviceable parts inside the EPre. Opening the EPre will

invalidate any warranty offered. Servicing must be referred to qualified service personnel only.

Burn in period

As is usual with high end audio equipment, when you first power up the EPre, you may not experience the

maximum performance of this pre-amplifier, the EPre can require a burn in period of up to 100 hours.

Additionally the performance of the EPre can vary slightly over its warm up period.

Page 6