- ページ 10

ネットワーク・ルーター Cisco NCS 540 SeriesのPDF 設定マニュアルをオンラインで閲覧またはダウンロードできます。Cisco NCS 540 Series 19 ページ。 Arp commands

ページを印刷する
Cisco NCS 540 Series 設定マニュアル

route distance

Task ID
Task
ID
cef
Examples
The following example shows how to enable proxy ARP on HundredGigE interface 0/0/0/0:
RP/0/#(config)# interface
RP/0/#(config-if)# proxy-arp
route distance
To configure route distance for a given Direct Attached Gateway Redundancy (DAGR) group, use the route
distance command in DAGR peer interface configuration mode.
route distance normal normal-distance priority priority-distance
Syntax Description
normal normal-distance
priority priority-distance
Default for normal-distance default is 150 and the default for priority-distance is 5.
Command Default
DAGR peer interface configuration
Command Modes
Command History
Release
Release
6.0
The default setting for a priority distance takes precedence over that of a typical Internet Gateway Protocol
Usage Guidelines
(IGP). The normal distance setting does not.
When this setting is applied, the DAGR group is updated in the database.
Task ID
Task
ID
cef
Examples
The following example configures a DAGR group peer with a normal route distance of 48 and priority
route distance of 5:
RP/0/(config-if-dagr-peer)# route distance normal 48 priority 5
RP/0/(config-if-dagr-peer)#
ARP Commands
10
Operations
read,
write
HundredGigE 0/0/0/0
Sets normal route (administrative) distance. Range is 0 to 256.
Sets priority route (administrative) distance. Range is 0 to 256.
Modification
This command was introduced.
Operations
write
ARP Commands