- ページ 9

産業機器 CAB 3014 L/R 2100のPDF 組立説明書をオンラインで閲覧またはダウンロードできます。CAB 3014 L/R 2100 13 ページ。 Front-side applicator

Mounting

3.2

Mounting the blow tube

Fig. 4

Mounting the blow tube

It is possible to rotate the blow tube to optimize the support with the support air for the take over procedure of the

label from printer to applicator.

1. Loosen screw (1).

2. Put in the blow tube (3) into the hole A (2).

3. Tighten screw (1) easily to secure it.

3.3

Attention!

Adjustments and function control was made with a compressed air value of 4.5 bar. The applicator

operating range is between 4.0 and 6.0 bar.

Warning!

When the applicator is connected to the compressed air cylinder movements are possible.

 Do not reach into the zone of the moving pad and keep long hair, loose clothes, and jewelry distant.

Fig. 5

Compressed air connection

Note!

If the pad is not in the start position when the printer is switched on an error message appears on the

display.

Press button pause at the printer.

The applicator will move into the start position and is ready for work.

Note!

Mount and use the air pressure regulation unit only in the shown orientation. Otherwise the function of the air-water

separator can not be guaranteed.

1 Check that the stop valve (2) is closed shown

in figure 11.

2. Attach compressed air at the fitting (1).

3. Open the stop valve (2) .

4. Switch on the printer by the power switch.

It is possible to use a air pressure regulation unit

Air pressure regulation unit with included

magnetic valve (3)

Controlling via printer

 Interface description of the printer

Air pressure regulation unit (4)