- ページ 10
産業機器 CAB WICON SQUIXのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。CAB WICON SQUIX 18 ページ。 Wrap-around applicator
ページを印刷する10
3
Replacing Assembly Units
3.4
Replacing the Guard Plate
1a
2
Fig. 7
Replacing the guard plate
Remove the covers and the centering panel at the gear side.
Loosen two screws (3).
Loosen two shoulder screws (1a,1b) and remove the guard plate (4).
Mount the new guard plate and if necessary new washers (2) as shown in the figure.
Tighten the shoulder screws (1a,1b) slightly.
Mount the centering panel.
Fig. 8
Tighten the shoulder screws
i
Note!
The applicator must be operated with the printer to adjust the shoulder screws.
Caution!
!
Risk of hand injuries
Do not grasp in the area of the turning winder plate!
Insert a product (5) to close the centering panels. That way the shoulder screw (1a) is reachable.
Press repeatedly the single-step button
touch guard will be hindered.
Press again repeatedly the single-step button
guard can move without hindering.
Adjust the shoulder screw (1b) in the same way.
Mount the covers.
2
1b
2
3
1a
5
4
2
1b
and tighten the shoulder screw (1a) until the movement of the
and loosen slightly the shoulder screw (1a) until the touch
10