- ページ 16
産業機器 CAB WICON SQUIXのPDF サービスマニュアルをオンラインで閲覧またはダウンロードできます。CAB WICON SQUIX 18 ページ。 Wrap-around applicator
ページを印刷する5
Error Treatment
16
i
Note!
The following table describes the reasons for error messages which occur repeatedly or permanently.
Message
Touch guard error
No label on belt
detected
Product release
failed/
Wrapping failed
Table 2
Error/Reasons
Failure of the touch guard movement
•
Shoulder screws at the guard plate
tightened to hard
•
Washers worn
•
Guard plate worn
•
Drive defective
•
Sensor touchguard defective
•
Cable sensor defective
•
PCB Control defective
After a labeling cycle is started no label is
detected on the transport belt
•
Label transfer from the printer failed
•
Transport module defective
•
PCB Spring Contact soiled
•
PCB Spring Contact defective
•
Contacts at the PCB Sensor Labels
worn
•
Sensor labels defective
•
PCB Control defective
Failure of the wrapping unit movement
•
Belt tension not correct
•
Chuck jaws hard-steering
•
Drive defective
•
Sensor Reference+Diameter defective
•
PCB Spring Contact soiled
•
PCB Spring Contact defective
•
Contacts at the PCB Sensor Labels
worn
•
PCB Control defective
Error treatment
Remedy
Adjust the shoulder screws
Replace the washers
Replace the guide plate
Replace the motor touchguard
Replace the sensor touchguard
Replace the cable sensor
Replace the PCB Control
Check the peel-off behavior
Adjust the peel positions in the printer setup
and the software
Replace the transport module
Clean the contacts
Replace the PCB Spring Contact
Replace the PCB Sensor Labels
Replace the PCB Sensor Labels
Replace the PCB Control
Adjust the belt tension
Removing the winder plate and pulling-off the
cam plate
Checking the movability of the chuck jaws in
the winder plate
Replace the motor winder
Replace the PCB Sensor Diameter
Clean the contacts
Replace the PCB Spring Contact
Replace the PCB Sensor Labels
Replace the PCB Control
16