- ページ 12
ネットワーク・ルーター Cisco WS-X45-SUP6-E - Supervisor Engine 6-EのPDF インストールと設定の注意をオンラインで閲覧またはダウンロードできます。Cisco WS-X45-SUP6-E - Supervisor Engine 6-E 30 ページ。
ページを印刷する
Removing the Supervisor Engine
Maximum Cable Distances
Table 3
Table 3
Transceiver
Speed (Mbps)
10
10
100
100
100
1000
1000
10 GB
10 GB
Removing the Supervisor Engine
All Catalyst 4500 series switches support hot swapping, which lets you install, remove, replace, and
rearrange supervisor engines and switching modules without powering the system off. When the system
detects that a switching module has been installed or removed, it runs diagnostic and discovery routines
automatically, acknowledges the presence or absence of the module, and resumes system operation with
no operator intervention.
This section contains the following subsections:
•
•
•
When installing modules in a chassis with empty slots, populate the upper empty slots first and work
Note
down.
Only trained and qualified personnel should be allowed to install, replace, or service this equipment.
Warning
Statement 1030
Warning
Ultimate disposal of this product should be handled according to all national laws and regulations.
Statement 1040
Installation and Configuration Note for the Catalyst 4500 E-Series Supervisor Engine 6-E
12
shows the maximum cable distances for transceiver speed and cable type.
Maximum Cable Distances
Cable Type
Category 3 UTP
MMF
Category 5 UTP
MMF
MMF
SMF
MMF
SMF
MMF
Required Tools, page 13
Installing the Supervisor Engine, page 14
Removing the Supervisor Engine, page 16
Maximum Distance
Duplex Mode
Between Stations
Half or full
328 ft (100 m)
Half or full
1.2 mi (2 km)
Half or full
328 ft (100 m)
Half
1312 ft (400 m)
Full
1.2 mi (2 km)
Half or full
43.4 to 62 mi (70 to 100 km)
Full
1804 ft (550 m)
Half or full
24.84 mi (40 km)
Full
984.3 ft (300 m)
78-18337-01