- ページ 2

ネットワーク・ルーター Cisco XR 12816のPDF リパッキング・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco XR 12816 26 ページ。 Cisco systems router owner's manual
Cisco XR 12816 にも：インストレーション・マニュアル (41 ページ)

ページを印刷する

Repackaging the Routers

Note

The Router Shipping Package

Cisco XR 12416 and Cisco XR 12816 Router Chassis Installation Guide

A-2

This section contains the following information and procedures:

The Router Shipping Package, page A-2

•

Tools and Equipment, page A-6

•

Safety Recommendations, page A-6

•

Removing the Router from the Rack, page A-7

•

Installing the Router on the Shipping Pallet, page A-16

•

Completing the Repackaging, page A-23

You must use the original shipping package supplied by Cisco when repackaging

the router. If you do not have the original system package, contact your

Cisco service representative for assistance.

Figure A-1

shows the router in an exploded view of the parts making up the

shipping package components.

Because of the weight and height of the router, the router shipping pallet

incorporates a scissor-jack platform. This scissor-jack platform enables a team of

two installers to remove a fully-loaded router from the pallet and insert it into an

equipment rack, or extract a fully loaded router from a rack, without removing any

of the components from the router chassis.

The router should be bagged to protect it against dust and electrostatic discharge

(ESD) and secured to the scissor-jack platform by four anchor clips. The anchor

clips are inserted into slots along the bottom edges of the router chassis side

panels and secured to the scissor-jack platform by four bolts. In turn, the

scissor-jack platform is secured to the shipping pallet by eight hold-down brackets

that are bolted to the top of the shipping pallet.

The shipping pallet consists of a U-shaped wood and foam pallet body and a wood

and foam pallet front bar. The pallet front bar fastens to the open end of the pallet

body to create the fourth bearing surface for the scissor-jack platform and to

complete the base needed to support the walls of the shipping container.

Appendix A

Repackaging the Router

OL-17440-01