- ページ 33

無線アクセスポイント Cisco 1004 - 1004 RouterのPDF 配備マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 1004 - 1004 Router 40 ページ。 Lightweight access points

ページを印刷する

Deployment

Collecting Tools and Materials

Before you start a site survey, you must collect some items:

•

Selecting Cisco 1000 Series Lightweight Access Point Locations

Using the Cisco Radio density estimate from

guidelines for placing Cisco 1000 series lightweight access points described in

Lightweight Access Point Placement

series lightweight access points in a typical test coverage area.

Preparing Optional Cisco 1000 Series Lightweight Access Point Tripod Test

Assemblies

You do not need to use the optional Cisco 1000 series lightweight access point tripod test assemblies

described in this section--you can tape or cable tie the Cisco 1000 series lightweight access points to the

ceiling, or place them on tall cabinets or ladders. However, if you must move them from their original

positions, having them mounted on the tripod test assembly stands makes it easier to relocate them.

You only need AC extension cords if you have enough 110 VAC electrical outlets within easy reach of

Caution

all potential Cisco 1000 series lightweight access point mounting locations. If you do use AC power

cords, make sure you use duct tape to avoid creating trip hazards with the extension cords.

78-17279-01

Maps or building plans of the areas to be covered, with a feet or meters scale included.

Duct Tape and Cable Ties.

T-10 Security Torx screwdriver.

A PC with a crossover CAT-5 or higher Ethernet cable capable of establishing a telnet session with

each Cisco 1000 series lightweight access point.

A Site Survey Tool, consisting of a computer equipped with 802.11a and 802.11b/g transceivers and

the signal strength monitoring and recording software.

Between one and five Cisco 1000 series lightweight access points with power supplies:

Cisco 1000 series lightweight access points.

–

Available Power Sources:

–

* Recommended factory-orderable 110 VAC-to-48 VDC power supplies.

–

* Optional Ethernet Power Injectors: Single RJ-45, 300 mA 48 VDC output, (MILAN Model

–

MIL-L1611, or equivalent). Refer to

Access Point Tripod Test

Recommended temporary stands, such as photographer's telescoping lighting stands, that can

–

be raised to ceiling height. Refer to

Point Tripod Test

Assemblies" for more information.

Optionally, you can temporarily position the Cisco 1000 series lightweight access points at or

–

near ceiling height using ladders and/or tall bookcases, but they do not offer the portability of

the Cisco 1000 series lightweight access point tripod test assemblies.

"Preparing Optional Cisco 1000 Series Lightweight

Assemblies" for more information.

"Preparing Optional Cisco 1000 Series Lightweight Access

"Determining Deployment

Guidelines," determine the location for three to five Cisco 1000

Deployment Guide: Cisco Aironet 1000 Series Lightweight Access Points

Optional Minimal Site Survey

Requirements" and the

"Cisco 1000 Series