- ページ 13
プロジェクター Epson V11H128020 - PowerLite S1 SVGA LCD ProjectorのPDF 製品情報マニュアルをオンラインで閲覧またはダウンロードできます。Epson V11H128020 - PowerLite S1 SVGA LCD Projector 15 ページ。 Epson powerlite elpmbuni: installation guide
Epson V11H128020 - PowerLite S1 SVGA LCD Projector にも： 仕様 (2 ページ), クイック・セットアップ・マニュアル (7 ページ), インストレーション・マニュアル (19 ページ)
ページを印刷する
EPSON PowerLite S1 Projector
2. Turn the projector upside-down and use a small vacuum
cleaner designed for computers and other office equipment.
If you don't have one, use a dry, lint-free cloth.
Note: If the air filter is difficult to clean or if it is broken, it should
be replaced. See the next section for instructions.
Spare lamps are provided with new air filters. When replacing the
lamp, please replace the air filter at the same time.
Replacing the Air Filter
If you need to replace the air filter, you can obtain it in the
following ways:
❏ Purchase one from your dealer
❏ Call EPSON at (800) 873-7766 or visit the EPSON Store
at www.epsonstore.com (U. S. sales only). In Canada, please
call (800) 463-7766 for dealer referral.
Note:
If you are also replacing the lamp, you can use the new air filter
that comes with it.
Follow these steps to replace the air filter:
1. Turn off the projector and wait for it to cool down.
2. Disconnect the power cord.
3. Turn the projector upside-down. Push in the tab on the air
filter cover and lift up the air filter cover to remove it.
12 - EPSON PowerLite S1 Projector
4. Replace the air filter with a new one. Make sure there are no
gaps between the air filter and the plastic grill.
5. Insert the air filter cover tabs, and then press down on the
opposite side until it clicks into place.
Replacing the Lamp
The projection lamp typically lasts for about 2000 hours of use.
SM
It is time to replace the lamp when:
❏ The projected image gets darker or starts to deteriorate.
❏ The
error light on top of the projector is flashing red
in 0.5-second intervals.
❏ The message
LAMP REPLACE
the projector lamp comes on (after about 1900 hours of use).
To maintain projector brightness and image quality, replace
the lamp as soon as possible after you see the message.
Request replacement lamp part number V13H010125.
Note:
To view the number of hours your lamp has been used, check the
About menu.
Warning:
Be extremely careful when removing the lamp module. Let the lamp
cool before replacing it. If the lamp breaks, handle the shards
carefully to avoid injury. In the unlikely event that the bulb has
ruptured, small glass fragments may be present and should be
removed with caution. If your projector is mounted on the ceiling,
you should unmount it before accessing the lamp compartment.
This will make it easier for you to replace the lamp and minimize
the chance of any small glass fragments dropping from the projector.
5/03
appears on the screen when