- ページ 33

無線アクセスポイント Cisco 3800 SeriesのPDF クイック・スタート・マニュアルをオンラインで閲覧またはダウンロードできます。Cisco 3800 Series 40 ページ。 Password recovery procedure
Cisco 3800 Series にも：データシート (8 ページ), アプリケーションノート (41 ページ), トラブルシューティングマニュアル (15 ページ), データシート (20 ページ), 設定 (32 ページ), ユーザーマニュアル (7 ページ)

no ip routing

interface GigabitEthernet0/0

no shutdown

media-type 100BaseX

half-duplex

ip address 172.1.2.3 255.255.0.0

interface GigabitEthernet0/1

shutdown

no ip address

end

Step 10 Respond to the following prompts. Choose [2] to save the initial configuration:

[0] Go to the IOS command prompt without saving this config.

[1] Return back to the setup without saving this config.

[2] Save this configuration to nvram and exit.

Enter your selection [2]: 2

Building configuration...

Use the enabled mode 'configure' command to modify this configuration.

Press RETURN to get started! RETURN

The user prompt appears:

Router>

Step 11 Verify the initial configuration. See the "Verify the Initial Configuration" section on page 34 for verification

procedures.

Initial Configuration Using the Cisco CLI—Manual Configuration

This section shows how to display a command-line interface (CLI) prompt for configuration using the CLI, and it directs you

to documentation for the CLI configuration. You can use the CLI if the following messages appear at the end of the startup

sequence:

--- System Configuration Dialog ---

At any point you may enter a question mark '?' for help.

Use ctrl-c to abort configuration dialog at any prompt.

Default settings are in square brackets '[]'.

Would you like to enter the initial configuration dialog? [yes/no]:

If these messages do not appear, SDM and a default configuration file were installed on the router at the factory. To use SDM

to configure the router, see the "Initial Configuration Using Cisco Router and Security Device Manager (SDM)" section on

page 30.

For help with interface and port numbering, see the "Port Numbering" section on page 29.

To proceed with manual configuration using the CLI, enter no when the power-up messages end:

Step 1

Would you like to enter the initial configuration dialog? [yes/no]: no

Press Return to terminate autoinstall and continue with manual configuration:

Step 2

Would you like to terminate autoinstall? [yes] Return